SSP-3A Solid-state Preamplifier
Replaces pre-amps used in most standard Hammond tone wheel consoles. Carefully designed to faithfully reproduce the response of the original tube pre-amp when it was new.
Eliminate the intermittent static, crackling, loss of volume, and general degradation of sound quality that can be caused by aging components in the original pre-amp. STANDARD FEATURES:
- Built in reverberation utilizing a full size Accutronics three spring delay line
- Built in power supply
- Built in Leslie 122 tremolo control circuitry, functions with original tremolo switch or TS-2
- Built in power-on circuitry for 11 pin Leslies
- Functions with original swell pedal and linkage or can be used with remote floor type pedal
- For portable applications, a custom Ernie Ball volume pedal model EB-100K is available
Solid State preamp
WITH AUXILIARY AMPLIFIER CHANNELS
Provides 2 additional amplifier channels and a separate enclosure with input jacks, output jacks and level controls. These channels may be used to play other keyboard instruments, rhythm units, etc. through their own amplification system, but under the control of the organ swell pedal. In addition, either input can be routed through the organ sound system by moving a jumper on the circuit board. When configured this way, the AUX-1 input will be expressed, and the AUX-2 input will be un-expressed.
Amplifier with Auxiliary channels
OPTIONS:
TS-2 TREMOLO SWITCH
Mounts in place of the lower left hand end block on standard Hammond consoles. Allows convenient rocker switch control of the tremolo function. Normally provided with a two position switch. Also available with a three position switch for use with Leslies designed with a stop function. Pre-punched mounting hole provided for addition of a reverb or other control in the same enclosure.
NOTE: When ordered along with the RV-1C or SSP-3A , the TS-2 can be supplied with the reverb control pre-installed in the end block cover.
Tremolo switch
ECHO / ENSEMBLE / MAIN SWITCH
Provides all the features of the TS-2 with the addition of a three position ECHO / ENSEMBLE / MAIN switch compatible with 4H echo kit tone cabinet switching.
Echo / Tremolo switch
TP-3B PERCUSSION CONTROL HEAD
By adding the TP-3B percussion control head, the percussion circuitry of the SSP-3 can be utilized to add B-3 type percussion to older consoles which did not originally have this feature.
Percussion control head
BASS, TREBLE, AND PERCUSSION LEVEL
Provides precise control over the organ's bass, treble, percussion and overall level.
Mounted on the SSP-3A chassis, these controls allow the organ owner to set sound to his preference and not have to worry
Bass, Treble, and Percusion level
BTC-2A BASS, TREBLE, AND PERCUSSION LEVEL END BLOCK
Provides precise control over the organ's bass, treble, percussion and overall level.
The BTC-2A mounts in place of either left end block and gives the organist the ability to tailor the sound while performing.
Bass, Treble, and Percusion level end block
EFFECTS LOOP
Provides a separate enclosure with line level effects send and return jacks for adding the effects device of your choice to the SSP-3A
Effects loop option for SSP-3A
Ernie Ball volume pedal
Configured with a 100K pot to work with the SSP-3A remote swell option. Allows accurate control of organ swell without the mechanical linkage. Connects to the SSP-3A via a single standard 1/4" patch cord.
Ernie Ball volume pedal
Trek II is a registered trademark of Trek II Products, Inc. © Trek II Products, Inc., used with permission
|